Results 1 to 7 of 7
  1. #1
    Member
    Join Date
    Dec 2015
    Location
    Bartlett, Illinois
    Posts
    548

    WATER PRESSURE QUESTION

    I have a 2019 Mercury 200 HP PRO XS 4 stroke. I have about 50 hours on it now and the last couple of times out when i start the motor while sitting still the water pressure is at 0.7 but when I put in gear and idle slow it will read 1.7. A few times while sitting still with motor running the buzzer goes off and I shut it down as the throttle will not allow the motor to get the boat moving to get more water pumping. I have not run the motor out of water. Could it be the impeller going bad on its second year? I will appreciate any input and thanks in advance.

    Serial # 2B637429
    Mercury PRO XS 200 HP 4 Stroke
    22 Pitch Tempest Plus
    5850 wot rpm
    Smartcraft and an analog gauge
    Idle water pressure 0.7 and wot pressure 17
    Last edited by botrdav; 09-28-2020 at 09:17 PM.
    2019 Ranger Z 518 L
    200 Merc Pro XS 4 Stroke
    2016 Chaparral 246 SSI
    350 Mercruiser
    On new boat # 10

  2. Member
    Join Date
    Aug 2015
    Location
    Alabama
    Posts
    207
    #2
    Just a heads up, the moderator pretty much insists on a serial number for questions to be answered.
    http://www.bbcboards.net/announcement.php?f=203

  3. Member
    Join Date
    Dec 2015
    Location
    Bartlett, Illinois
    Posts
    548
    #3
    Thanks did not know that info was needed.
    2019 Ranger Z 518 L
    200 Merc Pro XS 4 Stroke
    2016 Chaparral 246 SSI
    350 Mercruiser
    On new boat # 10

  4. Mercury 3L/4 Stroke/Verado Moderator EuropeanAM's Avatar
    Join Date
    Apr 2008
    Location
    Greenville, SC (US)
    Posts
    95,217
    #4
    Yes, it is not only possible, it's probable. Recommend replacing (at least) the Impeller and the UPPER gasket.

    Yes, I know the service schedule says "3 Years or 300 Hours" for the water pump... but ANYTIME cooling system or overheating problems develop, you should ALWAYS, ALWAYS start at the SOURCE: The Water Pump.

    Be sure to check the (3) strainers as well (and clean them).


    Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
    Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
    Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor

  5. Member
    Join Date
    Dec 2015
    Location
    Bartlett, Illinois
    Posts
    548
    #5
    Thank You, Boat going to shop on Thursday, they think it is a sensor as when running there is a very strong water stream coming out of the water tube
    Last edited by botrdav; 09-30-2020 at 08:26 AM.
    2019 Ranger Z 518 L
    200 Merc Pro XS 4 Stroke
    2016 Chaparral 246 SSI
    350 Mercruiser
    On new boat # 10

  6. Member
    Join Date
    Dec 2015
    Location
    Bartlett, Illinois
    Posts
    548
    #6
    Finally got boat from shop. The problem was the base gasket for the water impeller blew out. All was replaced under warranty they even installed a new water impeller.
    2019 Ranger Z 518 L
    200 Merc Pro XS 4 Stroke
    2016 Chaparral 246 SSI
    350 Mercruiser
    On new boat # 10

  7. Mercury 3L/4 Stroke/Verado Moderator EuropeanAM's Avatar
    Join Date
    Apr 2008
    Location
    Greenville, SC (US)
    Posts
    95,217
    #7


    Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
    Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
    Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor