Results 1 to 4 of 4
  1. 09-17-2020, 02:32 AM #1
    RTRCraft
    RTRCraft is offline
    Member
    Join Date
    Aug 2020
    Location
    Prairie Grove, AR
    Posts
    329

    HDS12 gen3 audio connectivity issue

    So I just recently installed the JL Audio mm50 stereo in my BassCat Lynx. The mm50 has a Nmea2000 connection. So I got it all hooked up. Turned the unit n and double checked that the graph was getting the nmea signal from the audio source. It showed up under devices. The problem is when I click on the audio tab on the far left it opens up, but it just shows the audio cycling on and off. It will show what the radio is playing for about a second or two then it will show powered off. Which sucks because I can’t use it for what it was intended for. Any help would be great.
    Reply With Quote Reply With Quote
  2. RTRCraft
    RTRCraft is offline
    Member
    Join Date
    Aug 2020
    Location
    Prairie Grove, AR
    Posts
    329
    #2 09-21-2020, 11:01 PM
    Anyone?
    Reply With Quote Reply With Quote
  3. 721Proxs
    721Proxs is offline
    Member
    Join Date
    May 2010
    Location
    Lumberton, Texas
    Posts
    2,392
    #3 09-22-2020, 03:05 PM
    Not sure, I just connect mine via Bluetooth from my iPod and done with it...
    Jimmy
    Phoenix 721
    12" Bobs Hydro Plate
    Mercury 300 Xs
    Dave Bush Racing Kit
    28.5 Bravo
    Reply With Quote Reply With Quote
  4. Dan444
    Dan444 is offline
    Member
    Join Date
    Oct 2020
    Location
    Australia
    Posts
    1
    #4 10-12-2020, 07:52 AM
    I have the exact same issue although mine was working perfectly with my carbon and then following my updating of the mm50 software, same issue as your experiencing.

    Have logged a job with Jl requesting an older software version to correct the issue and have it operate as before.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »