I just purchased a 2016 Skeeter ZX250 that his been wrapped since new and will be re-applying the SKEETER and ZX250 Decals that we’re removed when the wrap was put on. Has anyone done this any what product did you use to reapply?? Spray adhesive, etc?? Thanks!!
Are they flat, domed or chrome type...?
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
Water and Dawn soap in a spray bottle. Spray the back of the decal and where it will be applied. Put it in place from top to bottom and squeegee the water out from the center outward in all direction.
USN Retired
2020 Basscat Caracal
2020 Mercury 225 ProXS 4s
They are the raised chrome letters and the ZX250 decal, the original adhesive backing was removed when they were taken off the boat the first time.
If the decals have a black foam type backing you are not supposed to use any application fluid to apply. Just clean the area with alcohol and apply. If the decals have a regular adhesive backing then the Dawn/water will work however we opt for Rapid Tac for application fluid. https://www.amazon.com/dp/B00PG8JGHO..._8W0yFbMDCBPC3. After application and before pulling the top paper off spray application fluid over the entire area and start squeegeeing from the center out. Leave the decal sit approx 30 minutes before pulling top layer. When pulling top layer, pull back towards (parallel ) the decal as flat as possible not away from it.
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
you can order new Skeeter letters from Skeeter, they come with the adhesive already on them and you just peel and stick
Reply With Quote