Results 1 to 5 of 5
  1. 08-29-2020, 09:22 PM #1
    Brently13
    Brently13 is offline
    Member
    Join Date
    May 2019
    Location
    Roscoe, IL
    Posts
    43

    Atlas Jackplate elay Issue

    Is anyone else having trouble with the relays on the Atlas Jackplate? I'm on my 3rd relay in 2 years, they are not cheap or readily available.
    Reply With Quote Reply With Quote
  2. mdtritn21
    mdtritn21 is offline
    Member
    Join Date
    Jan 2005
    Location
    Red Oak Va.
    Posts
    10,597
    #2 08-30-2020, 09:41 AM
    You may have to convert it over to a regular switch, I had to do that with my plate.
    Reply With Quote Reply With Quote
  3. Brently13
    Brently13 is offline
    Member
    Join Date
    May 2019
    Location
    Roscoe, IL
    Posts
    43
    #3 08-30-2020, 07:06 PM
    And get rid of the blinker trim switch?
    Reply With Quote Reply With Quote
  4. mdtritn21
    mdtritn21 is offline
    Member
    Join Date
    Jan 2005
    Location
    Red Oak Va.
    Posts
    10,597
    #4 08-30-2020, 08:20 PM
    If your talking about the up and down relays that move the plate up and down you can't by pass them. I was thinking about the dial that activates them. They are just solenoids aren't they. Have you tried putting dielectric grease on all the contacts so they don't corrode.
    Last edited by mdtritn21; 08-30-2020 at 08:26 PM.
    Reply With Quote Reply With Quote
  5. Mgfan58
    Mgfan58 is offline
    Member
    Join Date
    Jul 2017
    Location
    Mansfield, TX
    Posts
    187
    #5 08-31-2020, 08:11 PM
    Switch over to a Bob's relay pack. Works the same, but last much longer. You only have to reverse the blue and green wires to the motor. If you don't want to swap the motor wires, you can reverse the trim lever wires.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »