2007 ZX225 Blinker Trim not Working

[cldtx]

Hello - New to me 2007 ZX225 with Blinker trim installed previously, and not working. With a voltmeter at the switch, it appears to be signaling correctly; however, no response from the trim. The trim on the shifter, the motor and the bow work fine. Is there a location/harness where the blinker trim would be plugged in (e.g., under the console, at/behind the shifter, at the engine, or in the battery compartment)? Any ideas appreciated. Thanks!

[mrdeath]

Make sure it's getting power, on my 08 the power switch has to be on for it to work. Check the fuse labeled 'trim' in the fuse box. Mine is wired in somewhere under the console, but I haven't had to mess with it so that's about all I know.

[cldtx]

Thanks. I will double check. My primary trim works fine, so I think the fuse is OK, but I will check for a second one. From what I can tell it has power at the switch, but I am not sure where the leads go from there.