Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Jul 2020
    Location
    Ohio
    Posts
    7

    I NEED HELP! Manual jack plate

    I tried adjusting my manual jack plate tonight and I broke off a bolt. I finally got the motor where I want it. But I can’t tighten my bolts. They are in a bind with the two jack plate pieces. Any help is greatly appreciated!!!!

  2. Pat Goff
    Join Date
    Jun 2004
    Location
    Seadrift TX
    Posts
    10,942
    #2
    Hopefully it's not a rite hite? If it is, just replace it.
    If it's something else, soak it down in penetrating oil and get a bolt extractor. NOT easy and NOT fun.
    After you get it fixed always use anti seize when you put it back together.
    https://www.amazon.com/IRWIN-HANSON-...tooladvisor-20
    Pat Goff

    Two degrees from center
    of nowhere.
    Smithwick TX.

    [SIGPIC][<a href=http://www.bbcboards.net/image.php?type=sigpic&userid=583&dateline=1498828542/SIGPIC] target=_blank>http://www.bbcboards.net/image.php?t...828542/SIGPIC]</a>

  3. Member
    Join Date
    Mar 2017
    Location
    Texas
    Posts
    94
    #3
    Is there a nut on the inside of the Jack plate or is it just a threaded bolt?