-
Member
Promax prop ID
Is this a labbed prop, the only markings I can fine on it, Was purchased as being one
20200803_103437 (1).jpg
-
Moderator
Normally when "Mercury" Lab finish's a prop, It's not polished, But a satin finish... When Mark B&BP/Lab finish's a prop it is polished.
-
Member
-
Both of my lab promax props have LAB stamped in the hub.
-
Member
-
Member
Tried the prop out this AM.
No cave ring and 4 solid plugs
Hole shot does not flash up as quick, at nose over flares to 5000 rpm but holds there even at full throttle, slower hole shot time than the 25 fury
No steering torque and drives like power steering at 3 in p to p
about 1 mph slower than the fury
Solved my handling problem, a little walk 71 to 75 and then no walk at all
Now the boat does not demand 150 lbs extra weight on the starboard side, reversed drivers and handle the same, 150 lb vs 325 occupants
Bullet90 William the phone call really helped build confidence in being on the right track
Will be trying higher settings to fine tune, I suspect the hole shot can not be improve much
As always Michael appreciate your expertise so much
Thank you both for the help Leon Pugh
-
If your running all holes plugged try a ring it helped my 27" which doesn't have any holes in it.
-
Member
Aluminum ring came in the mail today, Will give it a shot and vent as needed
Thank you sir