Thread: Graph set up

Results 1 to 5 of 5
  1. #1
    Banned
    Join Date
    Jun 2017
    Posts
    209

    Graph set up

    going to be putting 2 helix units at console and garmin at bow with panoptix. What is the best way to go about powering these units? Should I invest in another battery and stealth charger also? Any input would be appreciated. Thanks

  2. Member
    Join Date
    Jan 2005
    Location
    Red Oak Va.
    Posts
    10,597
    #2
    Pull new wiring to a new fuse block under the console then new wires to the console units and new to front. What size battery you have now and what motor will dictate if you need another battery.

  3. Member
    Join Date
    May 2018
    Location
    DeSoto, IL
    Posts
    409
    #3
    Quote Originally Posted by mdtritn21 View Post
    Pull new wiring to a new fuse block under the console then new wires to the console units and new to front. What size battery you have now and what motor will dictate if you need another battery.

    This except the console power cords can be directly connected to the fuse block as they’re plenty long.

  4. Member
    Join Date
    Apr 2021
    Location
    Detroit, Michigan
    Posts
    1
    #4
    Any recommendations on gauge wire from battery to console fuse block?

  5. Member
    Join Date
    Jan 2005
    Location
    Red Oak Va.
    Posts
    10,597
    #5
    10 gauge