Could someone tell me where to install the water pressure sensor on a 2019 Mercury 150 Pro Xs, Fourstroke, S/N 2B609617? I have the Vessel View and would like to read the water pressure on it. Thanks
Could someone tell me where to install the water pressure sensor on a 2019 Mercury 150 Pro Xs, Fourstroke, S/N 2B609617? I have the Vessel View and would like to read the water pressure on it. Thanks
Last edited by zamazoz; 07-25-2020 at 04:59 PM.
If you would, please take a moment to review the Announcements at the top of the Forum, and be sure to provide the Required Info (serial number) when posting. Thanks!
Moving your thread to the 4-stroke Forum for you....
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
Do a search on here. It's already been defined.
Left side about 3/4 up.....closer to back than front. It is where your analog gauge connects.
I did, there’s nothing about where to mount the sensor on the 150 Pro XS four stroke.
There should be a plug tied up in the harness near the location. It is labeled as water pressure. There is a hex plug in the engine right below it. If you have any issue finding it, I will send you a picture.
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor