Glad this worked for you!!To add to the success thread! I did a little experiment with the Hydromotive P-5 prop that I sent back. After a long talk and a little analysis on what has worked and what was not working we decided to try a odd modification to my 28 P-5. We cut the diameter down to 14 3/8 to see if I could turn the prop better on the bottom end and spin up quicker for a decent hole shot. Well I am happy to say it freaking worked! Not a 2-4 second break your neck hole shot but with empty wells and half tanks it was a good 5-6 second hole shot and with full wells I was getting 6-8 second hole shots. Huge improvement over past results. So it was the same or better than the 26 Bravo I had been running in tournaments. Top end was better also. Now I had crappy conditions and very short areas to push it but I did get her up to 84.8 with plenty left. It does drive very different than the Bravo FS so I have a little learning curve. I also think that i should not of had the barrel trimmed but Hydro suggested it before we trimmed the Diameter. I really think that I will get 86-87 out of the prop under good conditions. The mid range was also much better than when it was a 15 inch diameter prop. I am not sure that this will help everyone that is having hole shot problems but it was a small success that could lead down a trail of many successes and I did not lose any speed going down to a smaller diameter. I will post more results as I run the boat and get better water to push some of the limits. Cheers