Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    May 2011
    Location
    Apex, NC
    Posts
    1,993

    Hot foot set screw/ stop

    Looks like stop/ set screw backed out of hot foot. See lock washed and nut. Didn't fine bolt. How do I know how far to set?
    Attached Images Attached Images
    Last edited by bbbill; 07-14-2020 at 08:05 PM.

  2. Member
    Join Date
    Dec 2013
    Location
    Spring Hope,NC
    Posts
    7,253
    #2
    Go someone to watch the throttle stop on the engine while you press the hot foot. Set the stop screw at WFO.
    Get someone

  3. Member
    Join Date
    Jul 2020
    Location
    Elizabethtown, Kentucky
    Posts
    1,131
    #3
    Be careful that you don't go past 100% on the throttle setting. When I first had my Land & Sea foot pedal installed there was no stop/set screw and even though I was not actually going above 100% the CPU in the engine thought I was so it would go into limp mode to keep it from blowing up. We found that when we put it on the computer and it was showing 102% at WOT. Put a bolt in to stop the throttle and never had a problem with it since.