Bought a used boat and motor. How do I know what prop I SHOULD be running ? Thanks
Bought a used boat and motor. How do I know what prop I SHOULD be running ? Thanks
If you post what motor, boat, propeller, pitch, RPMs, speed, etc. and tell us what it’s doing or not doing. Then you can get some recommendations. But not until then.
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
I have the same question !! 2002 Ranger 205vx 225 Optimax Trophy 25 1/2 Plugs best I can get is 53@5200. 6” Hyd Jack Plate. Works fine except at Clear Lake, Ca where it “Blows Out as it starts to break over even lowering the plate. Clear Lake is mostly shallow 2-15’, but it still happens in deeper water too. Clear Lake is 1400 elevation, but works fine at 1087 on the highest I normally fish. Could the extra 300 feet make that much difference ??
Last edited by wmitch2; 07-10-2020 at 03:40 PM.
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
Many of the big block motors on heavy boats and loads don't like a small diameter prop, small tube, and without a flared barrel.... Like a trophy plus.
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
You guys that run in higher elevations need to prop your boat for horse power it makes at those altitudes . A 25 pitch woulD be fine At low elevations . But your basically running less than what the sticker is on the motor . Drop down a pitch or two and get the motor in the correct rpm range .