been trying to figure out why my app doesn't allow me to adjust speed on individual remotes. i thought i had 2.0 pumps but seems i may have 1.0.
does the 1.0 not allow for setting the remotes speed for each one?
been trying to figure out why my app doesn't allow me to adjust speed on individual remotes. i thought i had 2.0 pumps but seems i may have 1.0.
does the 1.0 not allow for setting the remotes speed for each one?
Last edited by Jason1; 07-07-2020 at 07:55 PM.
CM1.0 still have the capability to adjust remotes via the application.
The dash remote can also be done via the selector switch found on the remote itself.
The Key FOB and Foot Buttons would be done via the application.
Are you on Iphone or Android platform?
i am using the app on an android device.
Following
Richard Woods VA Beach,VA
US Navy ETC/SS Retired
SKEETER ZX225 / 225 SHO W/Power Pole CHARGE
GET HER DONE! (Helix 10 G3, 12 G3,Garmin ECHOMAP 106 /livescope and M360 Bow all NMEA2k)
Relion lithium batteries for T/M and LithiumPro for Motor)
You should be able to go into the “remote control max settings” and then it should say something about remotes and once you click on that it’s a little slider bar. When you back out of the application it should save the settings.
Last edited by Hydrilla Gear; 07-14-2020 at 01:05 PM.
mine doesn't have anything other than a slider for speed, auto/manual button, and up and down arrows. my app also is just a white background. all the videos i have seen has a orange background. just figured i had an older version.
I also just noticed my firmware version is 00.26.
And not the newest firmware. But cannot find anyplace to update.
well i found it, i feel dumb now...
my app looked different than what i was seeing online. there was an arrow at the bottom i couldnt hardly see. thanks for the replies!