Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Jul 2004
    Location
    Evans, Ga
    Posts
    151

    Passenger rod ramp, side panel, cockpit side panel issue

    I had a 2010 Z520 and the panels were like a dashboard on a car/truck. The newer Rangers I'm looking at if they are a few years old the composite material looks oxidized or faded real bad. Looks chalky gray instead of black the way it came. What do use on these to make black again and stay that way.
    Danny Collier - Evans, GA
    Ranger Z520 / Mercury 250 ProXS


  2. Member
    Join Date
    Nov 2011
    Location
    Shawano WI
    Posts
    577
    #2
    I’ve had good luck with 303 Aerospace breathing new life into dash panels and black trim.

  3. Member
    Join Date
    Feb 2008
    Location
    Douglasville GA
    Posts
    218
    #3
    Ok I had a Z20 that had the panel like you described on your Z520. I have a 2015 Z520C and it has the panels that do tend to fade if you don’t treat them. The 303 spray works fine to keep them looking fresh and new. If you are looking at a boat where it has been neglected, yes it fades pretty badly. You can use a blacking compound made for car black molding to give it that fresh look. I did that with mine after I had left it neglected. So yes if you get one of these boats they do required attention to keep them looking fresh.
    2015 Ranger Z520C Yamaha 250

  4. Member
    Join Date
    Nov 2019
    Location
    Mineola, TX
    Posts
    4
    #4
    This! Cerakote - Trim coat