Hello Guys, I was hoping to get some info on connecting/wiring my Mega 360. I am installing an Ultrex Mega 360. I have two bow Helix units, both G3, one is an MDI +, the other is an MSI +. I am exclusively using the MSI for the Mega 360. I am taking off an Ultrex 360 unit, which I had connected to my MSI+ unit. My old 360 unit was connected via Ethernet through my 5 port switch and my power went back to my boat switch and then to my battery. Because of the short 1' wires on the Mega 360 it makes it easier to connect the Mega 360 to the MSI+, direct, no Ethernet, but the power configuration is backwards, so my current power setup does not work. Am I going to have to install a 10 gauge wire all the way to the boat switch and a 1 amp fuse holder in-line close to the battery. My other thought was to somehow use my existing power wiring in the front of my boat and just install a 1 amp fuse holder. Any suggestions would be greatly appreciated. I think I would still connect the Ethernet cable to the back of the MSI+ unit and use the same power cable for the MSI+, but I believe the Mega 360 needs a separate power source.
Good Fishin!!!
Dan