I have a cobra 188s and would like to install a recessed tray for the foot pedal. Does anyone know of any obstacles or braces and what not that may be under the deck ?
I have a cobra 188s and would like to install a recessed tray for the foot pedal. Does anyone know of any obstacles or braces and what not that may be under the deck ?
Following.
Leave 3 to 4 inches of carpet between where the front of the tray will go and the plastic trim of the bow panel. There's an angled piece of plywood under that area. Other than that, lots of foam to cut out.
Tom
Installed one in my 201 coosa. Like Tom said lots of foam lol. Well worth the effort.
Thanks for the info on the space in front. From just using a tape measure it looks like where I what to install it is going to be perfect.
I did mine and no problem just a ton of foam..
same here, 201d install, ton of foam. Incidentally, don't forget to seal cut deck edges with resin and apply a bead of sealant under the lip of the tray before setting in the hole to prevent water from seeping under it, through the carpet and waterlogging the foam below deck! If you start to see garage floor or driveway, you've removed too much foam
2000 VIPER COBRA 201D /225 Merc EFI SER: 0T054298
Where does the white go when the snow melts?
i put one in my 98' 201, and i think it's great!
Is there a specific brand of tray to use or any run of the mill tray?
Did one in my 201s no problem
USMC 1966 - 1968
Combat Vets Association Georgia Chapter 25-1
1999 Cobra 201S 2012 Mercury 200 Pro XS
Bird 798 & 1198 Minn Kota Ultrex