I have a C16 at my console and a 16 at the bow. They are etherneted together and they worked great together and I could source the image from the console unit and get sidescan image from the Totalscan transducer that is connected to it.
I am not real real tech savvy and the new electronics are way over my head so I don't wanna just start going into menus and pushing buttons but for some reason the image on my bow unit is not the same as the console unit. When I select downscan at the bow and select source from the console unit I get the downscan screen but the image is just a little compressed blob at the top center of the screen. It is a new problem and it worked as it should for several trips and now it's doing this out of the blue. I did not make any changes so not sure what happened. All the cable connections are solid but not sure where to go from here.