-
I think that I used the same brackets as you have. Mine are offset, as I could not find centered brackets. I actually used all the same brackets on my center hatch. They dont look just like factory, but I wasnt concerned with that. I will post a photo, but it is not the best. I could try to get a better shot in the morning. It is a tight fit on the fiberglass lip.20200525_162408.jpg
-
The RV Designer G845 is the exact size of the fiberglass lip. They do not hangover like in your picture.
-
-
The G845s are the same 4 sets later they are all the same, about to give up these brackets are impossible to find!
-
Will something like this work? I think a 1” bracket will work but I’m not sure if this is the right size ball. You can drill your own holes.
https://www.maxumhardware.com/catalo...roducts_id=658
-
The g845 is a 1” bracket. Fit perfect on my 2017 189. Assume the lip must be smaller on the OPs boat.
-
If you can't find the right size then take the one you have, measure it, cut it down and re-drill the hole. It would be worth the effort on the center forward hatch especially.