Has anybody replace trolling motor on these boats? Can't figured out how to go about mounting an minn kota ultrex. Really dont want bass pro to do it.
Has anybody replace trolling motor on these boats? Can't figured out how to go about mounting an minn kota ultrex. Really dont want bass pro to do it.
1978 hydrostream vandal comp
2011 hydrostream venom comp
1994 bullet 20xd
1985 ranger 340v
2017 xpress xp7
There should be a carpeted piece of aluminum up front that you can remove to get your hand in there. It's tight and a 2-person job but you should be able to get it done fine. With the Ultrex you put the mount on the nose of the boat before you secure the motor itself to the mount so not quite awkward as some trolling motors I've dealt with.
2023 Xpress H18 with 115 SHO and Powertech NRS4 21p
8" Bob's Action Jack
Garmin Echomap 12, 10, 9, and LVS34 networked with Netgear Switch
Ultrex
Trick Steps and Ramp N Clamp
Pulled by a 2016 single cab HEMI Ram
Treat others like you want to be treated when on the water EVEN WHEN IN A TOURNAMENT! No fish is worth having a confrontation because you cut someone off or came in on top of someone.
Ok thanks!
1978 hydrostream vandal comp
2011 hydrostream venom comp
1994 bullet 20xd
1985 ranger 340v
2017 xpress xp7
I have a PT 170 TX that I removed the stock Motor Guide 12V motor originally and installed a Motor Guide Tour 36V, then changed that to an Ultrex. I cut the access hole larger so I could get my arm in far enough to reach the front bolts to put washers and lock nuts on them. I crash into trees and stumps a lot and did not want to depend on the Motor Guide rubber isolators to hold.
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
Could not reach the front holes at the very end . Just drilled 2 holes about 1.1/2inches closer to be bolted down . Nice and sturdy , not going anywhere.( drilled the holes in trolling motor mount)
Last edited by Marky1; 06-25-2020 at 03:15 PM.
Clayton Bigsby? Just ask one of the guys in your club to give you a hand after your Friday night rally