Could someone please tell me how the T&H cap for my TM is a good investment?
Could someone please tell me how the T&H cap for my TM is a good investment?
Are you talking about the G-Force nut?
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
I can’t tell any difference
Had one on Ultrex and still had some vibration but the prop is not well made....took it off and put the factory nut back on.....
YOU are not entitled to what I have earned!!!!!
2014 Phoenix 619 Pro / 2014 Mercury 200 Pro XS
It doesn’t do squat other than fade after 6 months on the water. Been through 2 of them
The dealer included one on my boat. It looked cool but I didn’t see any other benefit. It can easily get over tightened and then is hard to take off. I removed it and am back to using the regular nut. Nice bling but that’s all IMO.
I put one on my last boat. It did not seem to make a difference. My current boat does not have one.
A buddy asked me a serious question that I could not answer...If you break the shear pin, how do you get the fancy prop nut off?
USN Retired
2020 Basscat Caracal
2020 Mercury 225 ProXS 4s
I never had any "Vibration" to get rid of, but the ease of removing the Prop with out any tools to remove any debris, or fishing line, was worth the investment for me.
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
The newer style like Bob's Machine Shop has a hole drilled down center to stick a screw driver in....
YOU are not entitled to what I have earned!!!!!
2014 Phoenix 619 Pro / 2014 Mercury 200 Pro XS
Not recommending the Eliminator, but at least on Minn Kota, They have what they are calling a "Drive" pin. I am not sure you can shear it. Bend it slightly, but doubt it can be sheared with a plastic prop.( Shearing a pin means there is no metal attached outside of the shaft so the prop can't be held in order to unscrew the Eliminator) JMHO Bob
Tell me where has a slow movin' once quick draw outlaw got to go
Last edited by trashmanssd; 05-25-2020 at 09:38 AM.
2020 Ranger 521L, Merc 250 Pro XS
Well for me, on a Motorguide Tour 109, it definitely works. Removed a ton of vibration.
I agree that it helps a bit. If I had it to do again, I would not bother. Bob
Tell me where has a slow movin' once quick draw outlaw got to go
Helped on mine. It does a better job of squaring a prop up, as the center of the prop is not very square on many of them. The nut squares by the face, not the center.
Yea, it also extends farther from the center which lessens the deformation from the water resistance. Like I said, helps some. Bob
Tell me where has a slow movin' once quick draw outlaw got to go