Results 1 to 5 of 5
  1. #1
    Member
    Join Date
    Feb 2009
    Location
    Overland Park KS
    Posts
    21

    Skeeter fuel guage not working

    2008 Skeeter XZ200. For about 2 years the fuel guage shows the port tank is always empty. Starboard tank seems to display accurate info. Problem (I think) is the fuel level sending unit in the tank is broken or the port/starboard selection switch/button is broken. I cant get to the switch because it is buried in a push button panel. Any ideas as how to test??
    Last edited by USMC Ret; 05-17-2020 at 07:53 PM.

  2. Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    25,172
    #2
    Check out this post http://www.bbcboards.net/showthread.php?t=735461

    Each tank should check out as described in the post when the switch is in the position to select it.
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​

  3. Member
    Join Date
    Feb 2009
    Location
    Overland Park KS
    Posts
    21
    #3
    Thanks. I'll try that tomorrow. In the meantime how do I move this post to a more appropriate thread??

  4. Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    25,172
    #4
    Quote Originally Posted by USMC Ret View Post
    Thanks. I'll try that tomorrow. In the meantime how do I move this post to a more appropriate thread??
    I reported it to get the attention of somebody who can move it.
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​

  5. Member
    Join Date
    Feb 2009
    Location
    Overland Park KS
    Posts
    21
    #5
    Problem solved. Chased 12v wire from sending unit to a 12 pin connector on the back of the dash panel and when I reinserted the connector the fuel guage displayed the correct fuel level for both tanks. Was it corrosion on just that one pin or had the whole connector vibrated loose over the years?