Anybody have a good tip on getting these things off? Other than using a heat gun.
Anybody have a good tip on getting these things off? Other than using a heat gun.
No.
I use a heat gun on lower setting.
Vic
Preparedness plus Opportunity = Luck
Just had to get my wife to help me because it took me 45 mins on one side. They are the worst! Finally they are blue to match my boat! It’s been awhile
2017 Nitro Z20 w/ Mercury 250 Pro XS
MK Ultrex 112# Mega DI/ Mega 360
Console: Helix 10 MDI G3N-Helix 10 MSI G3N
Bow: Helix 10 MDI G3N-Helix 10 MDI G4N
goo gone, hair dryer on low heat, plastic razor blades.
I stopped trying. I just put the next right on top of all the previous years
Well that was surprisingly easy. Used a heat gun on low then cleaned the area with some rubbing alcohol and put new stickers on. Start to finish was about 15 minutes. The stickers pulled off in one piece rather than a hundred as usual. Don’t know if it’s where KY changed the style or sticker or what.
Yelp, I did the same yesterday.
Vic
Preparedness plus Opportunity = Luck
One year while I was still working, the quality
of the decals were so bad you were lucky if they stayed
on any length of time. More like paper than vinyl.
A lot of times the boat owner didn't know the sticker had
fallen off. LDS
Larry D. Scott Retired KY Water patrol/F&W
www.greatscottshooters.com
2008 TRACKER TV 18 w/150 Mercury 4S
MK Ultrex 80lb, 102 Garmin Live scope
and a UHD93SV Garmin on the bow.
UHD 93SV at the console.
WD40 will remove stickers and residue when nothing else will
Tracker Panfish 16
Bonafide EX123 Kayak
Heat gun and razor blade, no damage and off in 2 minutes per side. Wd40 or rubbing alcohol will remove the residue
@kennethandmacy
2004 Triton 196
200 Merc
1199/898