Gen 3 units, LSS-2 Transducer. Last couple of times out I've noticed my console unit I use for structure scan has started picking up a lot of small white lines on side scan. Downscan on the same unit is fine, unchanged. Any ideas?
Gen 3 units, LSS-2 Transducer. Last couple of times out I've noticed my console unit I use for structure scan has started picking up a lot of small white lines on side scan. Downscan on the same unit is fine, unchanged. Any ideas?
Does it look like horizontal rain? I have an LSS1 that has started doing that on one side only. I think it is the transducer going bad.
I try to drive as if my 16 year old Grandson is following me
Speak as if he is listening and act as if he is watching
Exactly what it looks like. Only on the side imaging piece.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
They do get dirty, might use a wash cloth and see what if that helps.
Last edited by kennybryan; 04-05-2020 at 07:53 PM.
Both sides. Console unit is most noticable so yep at idle speeds. Dedicated power to all units and a new battery.
I will try cleaning the transducer. Thanks
There are 3 crystals in the transducer, Right Side, Left Side and Downscan. Since I only had rain on the Right side, I figured that Crystal was developing a problem.
There is one other possibility in my case because my Transducer is attached to an LSS-1 module.
For the moment, I am just putting up with it.
I try to drive as if my 16 year old Grandson is following me
Speak as if he is listening and act as if he is watching
My LSS-2 is directly to the head unit.
Might try cleaning the the connector pins.
Ranger R81
Lowrance HDS Live 9”
Lowrance HDS Live 12”
Active Target 2 on Seelite Pole
Lowrance Ghost
Mercury 175
I'll do that...thanks.