This is a picture of my Tank. Is there any possibility of adding a Gauge on top? Also I cannot get any gas from this tank to the engine. When I switch to the auxiliary the engine quits.
This is a picture of my Tank. Is there any possibility of adding a Gauge on top? Also I cannot get any gas from this tank to the engine. When I switch to the auxiliary the engine quits.
That's a saddle tank I never saw , my old boat had plastic. To prime it put the selector switch to the saddle and pump the primer bulb till its hard, it's probably in the rear cranking battery compartment . One way to watch the level when the tank is full reset fuel used on the merc monitor when you get to 8-9 gallons used switch back to main tank. I imagine it's a 10 or 11 gallon saddle you don't want to run dry at speed that's a lot of water coming over the back.
BULLET 21XRS 250 SHO
+2
I would test the fuel capacity with your merc monitor first. Once you know your fuel burnt capacity, then use that mark to switch tanks.
You can put a sender on the left hose outlet btw
BULLET 21XRS 250 SHO
BULLET 21XRS 250 SHO