Results 1 to 4 of 4
  1. 03-29-2020, 10:56 AM #1
    Ohbasser
    Ohbasser is offline
    Member
    Join Date
    Nov 2006
    Location
    SWOhio
    Posts
    256

    Question Fulton Trailer Jack

    I have a 2005 Marine Master Trailer. The trailer Jack is about shot & needs replaced.

    How do I identify what is on it now? (I searched on the Jack but couldn't find any info) it just says Fulton Made in USA on the top cap.

    Also, I have a single axle trailer that I have to angle it in to get it to fit in my garage.
    Last edited by Ohbasser; 03-29-2020 at 11:13 AM.
    Reply With Quote Reply With Quote
  2. CatFan
    CatFan is offline
    Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    26,088
    #2 03-29-2020, 11:29 AM
    How does it attach to the trailer frame? Bolts? Snap Ring?
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​
    Reply With Quote Reply With Quote
  3. Ohbasser
    Ohbasser is offline
    Member
    Join Date
    Nov 2006
    Location
    SWOhio
    Posts
    256
    #3 03-29-2020, 11:43 AM
    There's a welded piece to the frame. Then there's a center bolt.
    Reply With Quote Reply With Quote
  4. turfy49431
    turfy49431 is offline
    Member turfy49431's Avatar
    Join Date
    Oct 2014
    Location
    Virginia Beach
    Posts
    4,673
    #4 03-29-2020, 05:27 PM
    If you have to angle it get a 1500 pound with the big wheel that has the matching mount of yours
    Ranger R81VS, Mercury 175EFI w/ 25 Tempest
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »