I have recently bought 3 Tatulas (2 TW SVś) and one Tatula 100. All 3 make the same noise. Iḿ not sure how to describe it other than it sounds like line crunching when I cast. They aall work great, but anyone else notice a sound like that.
I have recently bought 3 Tatulas (2 TW SVś) and one Tatula 100. All 3 make the same noise. Iḿ not sure how to describe it other than it sounds like line crunching when I cast. They aall work great, but anyone else notice a sound like that.
Nope
Nope.
2023 Phoenix 819 pro
2023 200 Pro XS 4s 3B373365
pond boat
2020 pelican Bass raider 10E
No...probably have 2 dozen Tatula Elite Long Cast and Pitch and Flip and none do it. Have had a pile of all Tatula models over the years and none have done it.
Yea mine have never made noise and I have every generation since the beginning.
I have one that does that on the cast. It’s maddening.
Probably the inductor is stuck intermittently?
Everyone of mine made noise when fishing below about 45 degrees. Used WD40 to spray out the factory oil from the spool bearings and then added a drop of reel butter or Abu oil tool them. No noise since. Mine was more as BemisBasser described above. Noise during the cast.
Yes my tat sv sv makes noise on cast. Found youtube vids of the same issue. Others on TackleTour site have had the noise on cast with tat sv.
a few of my tat sv reels were noisy on the cast these were the first gen models i had a few tatula elites and fished them for a while no noise with them
Tatula sv. Noise while casting.
Have 2 SV’s, 2 CT’s and and a Tatula 100 and none have made any kind of noise.
Could be a sticky inductor
Had a Tatula sv that did this. Was very loud but didn’t seem to affect the performance of my reel. I took the reel apart and reoiled and lubed and no problems since.
I just bought a Tat 100 and it seems fine... no unusual noise that I've noticed. Just your standard casting noise.
Alex Darsen - 2013 Phoenix 920/Mercury 250 ProXS
Fishing is not a matter of life or death.
It's more serious than that!
I have 2 TTU100H's that both make noise on long casts. I can take out the bearing in the side plate, clean and re-oil it and they're fine for a while, but eventually get noisy again. Contemplating ordering some better bearings for them. Other than that, they're super smooth and quiet on the retrieve.
Reply With Quote