I was running the 3D structure scan module and transducer but my module isn’t working anymore. I pulled my 3D transducer and module and installed my old lss2 transducer until I can get my module fixed or replaced. After installing it I turned on my unit and I can’t find the Lss2 transducer in the installation setting. All it’s showing is the SS3D and several others but not my lss2. Does Anyone know what I will have to do to get it working?
You don't need to "install" a 9 pin transducer. Just connect it directly and on the Structure menu tap Source and select This Unit.
NoCAL
2004TR-21X/2015 250 ProXS
2B112175
You are saying I’d be able to use my same 3D transducer without the module?
I absolutely did not say that. Hope it wasn't implied. You were asking about your LSS-2. StructureScan 3D requires a module and transducer. LSS-2 does not need a module when direct connected to ANY Touch unit. The module is built into Touch units.
NoCAL
2004TR-21X/2015 250 ProXS
2B112175
Thanks for your help
Reply With Quote