87 procraft 1780v wiring
can anyone guide me in the right direction, I would like to change to a 36 volt trolling motor from a 12v but the wiring diagram on the shows there is a link between the two. Do I have to run separate cables to the trolling motor and keep the 12v to the plug intact?
How many wires are talking about? The only connection between the wires would be a jumper in a 3 or 4 wire system.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
87 procraft 1780 competitor wiring diagram.jpgI have 4 wires coming from the trolling motor receptacle
Your boat is setup for a TM that can run on both 12 and 24V, so two of the wires are connected together at the front. You’ll only need two wires for your 36, but you’ll need to put jumpers between the batteries.Originally Posted by RonMM1
87 procraft 1780 competitor wiring diagram.jpgI have 4 wires coming from the trolling motor receptacle
You may need new wiring and you will probably need a new circuit breaker. What gauge are the existing wires going to the front? Should be printed on the insulation.
Last edited by CatFan; 03-10-2020 at 02:24 PM.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
Wiring is 8awg and I have a 60A MKR-19 Minn Kota circuit breaker, length from plug to batteries is approx. 16-17ft, what happens to the other 2 wires, do they get disconnected a and which 2 wires at the plug.
the trolling motor is a Terrova 101 with I-pilot
By the way thank you for your help in advance
You can just stash the extra wires. You can use any two wires and pins.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
Reply With Quote