2 console units

[Basshaker]

here are pictures of the labels on the y cable. I'd expect the 720101-1 should be were the 490476-2 is if it was the correct part.

ycablepn.JPG
ycable.JPG

[Wayne P.]

here are pictures of the labels on the y cable. I'd expect the 720101-1 should be were the 490476-2 is if it was the correct part.

ycablepn.JPG
ycable.JPG

That is the 9 M SIDB Y cable, it has 6 pins in the display plug.
The AS SIDB Y cable has Side Imaging on the tag and has 5 pins in the display plug.

[Basshaker]

Excellent, thx Wayne!

[Wayne P.]

Excellent, thx Wayne!

Mine has that number on the tag and it does not match the Humminbird part number, noticed that on several accessories.

[Basshaker]

Mine has that number on the tag and it does not match the Humminbird part number, noticed that on several accessories.

One less part to buy

[Basshaker]

so out came the livewell plumbing late yesterday

junklivewell.JPG

So i ran out of light to learn the power was out in the storage unit.

emptybilage.JPG

Wayne i am ready for heat and a hammer!

[Wayne P.]

Before the heat and hammer, chip away all the excess epoxy around the transducer, THEN whack it.

[Basshaker]

Before the heat and hammer, chip away all the excess epoxy around the transducer, THEN whack it.

will do!

[Wayne P.]

One more thing, make sure the new transducer is working properly BEFORE you attach it to the hull---don't assume it is perfect.

[Basshaker]

One more thing, make sure the new transducer is working properly BEFORE you attach it to the hull---don't assume it is perfect.

Good reminder, I did test this one with a sand bag and some water in bilge. Looks like I did a good job epoxying this one lol

[Basshaker]

Well it came out pretty easy, cleaned up the outer epoxy as suggested first. Appreciate the tips!

bilgeempty.JPG