-
250 Pro XS Vessel View mount
Engine S/N 2B534653, could I get some suggestions along with pictures on where is the best place to mount the Mobile Vessel View module on a 2018 250 ProXS 2 Stroke. I recently purchased the system from Don and I failed to ask at the time of purchase.
-
Mercury 3L/4 Stroke/Verado Moderator
Remove the Terminator cap at the PCM, plug in VVM.
Install the Terminator Cap onto the VVM harness.
Pull module forward, and tie-wrap it as far forward (and high) as you can, without interfering with cowling or air-flow into Air Attenuator. Can often be put right on the front of the air-handler by adding a short 6mm bolt and a clamp (or ring-terminal type tie-wrap) to support it.
Sorry... didn't think to snap a picture of the last one I did.
-
Thanks Don, I connected the unit to my engine harness along with my phone, really pleased with the information that it provides. I was not sure where to mount the module.