Looking to see which transducer mount I should use on my jackplate. Ducer is the 3 in 1 and plate is an Atlas 12" hydraulic. Thx
Looking to see which transducer mount I should use on my jackplate. Ducer is the 3 in 1 and plate is an Atlas 12" hydraulic. Thx
I used the mount that came with the transducer and mounted it to the bottom of my hole shot plate
2018 Z520C Ranger Cup / Mercury 250 Pro XS Ser# 2B526947
Any chance you could snap a pic? Also curious if you had to use any wedges t get it level.
IMG_3195.JPG
This is my 3D transducer mounted to the bottom of my hole shot plate. I didn't realize I went with a 3D instead of a 3 in 1 when I posted. If you look below you will see how you can mount your 3 in 1 to the bottom of your hole shot plate.
IMG_3196.JPG
Here's what you need to do. Get a piece of aluminum angle and mount your 3 in 1 transducer to it like in the picture above. Then you can mount the aluminum angle to the bottom of your hole shot plate. This should work just like my 3D transducer is mounted in the top picture.
2018 Z520C Ranger Cup / Mercury 250 Pro XS Ser# 2B526947