hey guys i have a question. im sending my injectors to brucato to have them cleaned. my question is when i get them back and install them what should i torque them 4 10mm bolts to? i dont have a manual. the motor is a 2000 - 200 vmax ox66.
hey guys i have a question. im sending my injectors to brucato to have them cleaned. my question is when i get them back and install them what should i torque them 4 10mm bolts to? i dont have a manual. the motor is a 2000 - 200 vmax ox66.
Chris Owenby Owner
Smoky Mountain Jigs.com
Hand Tied Jigs, Spinnerbaits and much more
2000 Skeeter zx202c - 200 Yamaha Vmax OX66 VX200TLRY
I'll look at my manual this weekend and see what it shows.
thank you javelin. i appreciate you
Chris Owenby Owner
Smoky Mountain Jigs.com
Hand Tied Jigs, Spinnerbaits and much more
2000 Skeeter zx202c - 200 Yamaha Vmax OX66 VX200TLRY
Forgot to look. Will look tonight.
I just snugged mine in with a 1/4" drive ratchet, basically what it required to pull them. Head bolts and internal components are the only thing I torque besides the flywheel nut and intake assy. The closest I can find is 5.1lb with a 6x40 bolt in my manual. CJ
2002 X19 200HP OX66 HO Vmax,HPDI lower, it lives, thanks Hydro Tec.
Standard torque values
Last edited by ClarkBird; 02-18-2020 at 05:53 AM. Reason: change pic
Lake&Bay Boca
SHO
Because of the very light torque values, you probably need to use an inch pound torque wrench. Most ft.lb. torque wrenches don't work very well below 25 ft.lb. or so. On my Yamaha VZ225, those are sealed with an o-ring rather than a gasket which means that super accurate torque rate is not as important. They just need to be tightened good and snug. 50 or 60 inch pounds ain't much.
Wayne
thank you everyone, i sure appreciate you guys
Chris Owenby Owner
Smoky Mountain Jigs.com
Hand Tied Jigs, Spinnerbaits and much more
2000 Skeeter zx202c - 200 Yamaha Vmax OX66 VX200TLRY