Empty hole in dash

[BobR93]

Please give me ideas on what I can use to fill a hole in my Ranger 491 Dash...There was a Lowrance Flasher previously in the hole to give you an idea of the size.
Thank you for your time and ideas

[paulrodbender]

I’m in the same boat but haven’t given it much thought because I’m busy with other things on the boat but I need to come up with something also. I’ll cut a circle out of something or use a sticker.

[DrewFlu33]

If you have / want speakers or a sound system in your boat, several companies make head units that are made to fill those hole. Otherwise, might not be a bad idea to stick another flasher in it? They have value still!

[BobR93]

Thanks for the radio idea...A flasher is what is causing the problem. I have a working flasher in the boat now and someone is interested in buying it. I want to sell it to him, however, I need to come up with an idea to fill this hole before I take it out to sell

[brushsjigs]

pm sent

[JR19]

https://www.amazon.com/Marine-System...NsaWNrPXRydWU=

[cast n' jerk]

They make a simple blank plastic plug that pops into that hole. I took both old lowrance flashers out of my 97' Champion 202 and put these in their place. The one up front in the bow I mounted my hummingbird gps puck on to the plug and it looks like it was "factory" mounted.

[cast n' jerk]

I found the plugs at a local marine parts/service here on Lake Conroe.

[barkleyhawggitter]

Beer tap.

[M1RT]

Vexilar FL-10 flasher!

[crank68]

I use Starboard material cut to fit for voids in customers dashes unless they want an accessory as mentioned above.

[granite]

Magic 8-Ball.

[DiawaKid]

Lowrance Flasher holes can be covered by 4" delrin sliced 1/8" two disk and samwich them together one behind dash and one in front. Did it on my Procraft, but I cut hole out for Humminbird Transducer switch. I think I have 2 more of these Black Delrin pieces

[ChampioNman]

TH marine sells a hole filler, I installed a stereo to fill the hole.

[John Jackson]

Make 2 aluminum plates at least half an inch larger than the hole, then put one on each side of the hole and screw together. The make a mount for later electronics. I did this with a rectangular hole but it works on the same principal. Have the aluminum powder coated to match. Shoot me a PM with a phone number and I can send a photo of what I did.

[OkieBud]

I going to pull a radio in mine..

[bqtoot]

Beer tap.

hahahaha!

[alpine4x4]

Just cover it with a piece of starboard cut to fit.

[BigFishSteve]

I deflated a small basketball, inserted it and re-inflated. Hoping it helps with holeshot.

[GSXRFANIM]

I cut all the wires off my flasher, removed it, and wrapped it with 3M Carbon fiber vinyl. Then it fit right back in there