I purchased this boat / motor late last summer and it ran great but I am going to go through as much of this motor that I can as I do not have any records of what has been done to it and I do not want any surprises that I could have easily prevented with routine inspections and such.
I want to inspect the poppet valve. If it is clean and in good visual condition, should I replace it or just reinstall?
2004 Ranger 519VX
Yamaha VMAX 200HP OX66
Put the new mushroom style model in with a new spring.
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
Will do 21XDC!
Got it opened up, had to use some pliers to remove the valve as it was stuck so I am guessing that wasn't working too well??
Didn't look too bad and is all cleaned up and ready for new parts.
2004 Ranger 519VX
Yamaha VMAX 200HP OX66
Old on left, New on right...
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
Thanks again 21XDC!! The numbers I looked up for the new parts are an exact match to yours in the photo.
2004 Ranger 519VX
Yamaha VMAX 200HP OX66
purchased the new style as well but not sure which way it goes. Any pics on the direction of the new poppet?
Dome mates to rubber grommet.
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
Reply With Quote
.jpg)