Ranger Z520/Elite 9 TI

[duckband417]

Running a 2012 Z520 with an elite 9TI at the console and an elite 9TI at the bow. I want to add another elite 9TI to the console. I am running an LSS 2 transducer and a 83/200kz traditional through hull transducer. My units are linked via NEMA network. I want to run one unit at the console for mapping and 2d and the other for SI/DI off the LSS2. Is this as simple as adding another T connector to the NEMA backbone with a terminal then wiring the power source into the dash/electronic keypad? Where and how should I wire in the power cord for my additional graph at the console? Thanks for any help and direction that you can give.

[Team Colibri]

You would need ethernet (one cable) between the units to share StructureScan etc. Elite Ti does not have that.
NMEA2000 shares more simple data, like waypoints and enginedata.