Would anyone know where I could get the attached boat trailer round step? I would like to get one for my trailer. Thank you!
Would anyone know where I could get the attached boat trailer round step? I would like to get one for my trailer. Thank you!
I got one from Bass Pro for a Nitro trailer. Come with the rubber non slip pad. I think it was around $35 ?
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
Perfect; did they have them on the shelf or did you have to ask the parts department to order? I'm having trouble finding them. Thanks
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
That step could be a good thing. I have an angled post that holds my front roller and winch. I got a square thickwall aluminum post, about 1&1/2 inch, had some giant heat shrink left over from a previous project and put two layers around it. I took an old paint can metal cap and put it over the top under the shrink. I used three screw type radiator clamps ( big ones) and clamped it to the winch post. I use it when going over the bow after putting my boat on the trailer. It helps to have something sturdy to grab when stepping over the trolling motor. By the way, either turn the trolling motor off or disconnect it at that point.
I'm old, 77, weigh 285#, it supports me pretty well.
Depending on how you want it set-up, here's another option:
https://www.northerntool.com/shop/to...4243_200464243
I added the BassPro/Tracker step with pole to my Tracker PT190 along with the Northern Tool aluminum step and have been very pleased with the combination.
Joe B
2017 Tracker PT 190 TX
2017 Mercury 115 Pro XS
Mercury Spitfire X7 19” prop
51 mph @ 6240 rpms (RPMs from Vessel View Mobile) : full fuel tank and fishing load by myself
4.2 second Hole Shot (measured using Vessel View Mobile)
Engine mounted in 3rd hole
Minn Kota Ulterra-Link w/built in MDI 80 lb thrust 60” shaft
Humminbird Helix 12si Gen1 chirp on console
Humminbird Helix 15si Gen4 cho on bow
Humminbird Mega360
Dotline two step transom boarding ladder
Tracker trailer bow boarding step
Joe3, can you post a pic of your setup?
Joe B
2017 Tracker PT 190 TX
2017 Mercury 115 Pro XS
Mercury Spitfire X7 19” prop
51 mph @ 6240 rpms (RPMs from Vessel View Mobile) : full fuel tank and fishing load by myself
4.2 second Hole Shot (measured using Vessel View Mobile)
Engine mounted in 3rd hole
Minn Kota Ulterra-Link w/built in MDI 80 lb thrust 60” shaft
Humminbird Helix 12si Gen1 chirp on console
Humminbird Helix 15si Gen4 cho on bow
Humminbird Mega360
Dotline two step transom boarding ladder
Tracker trailer bow boarding step
2009 ELITE 210
Thanks Joe. Looks good. I like it.
Joe where do I need to look to find that step with the pole? I looked on bass pro and couldn't find it.
Great help and ideas all; thank you!
Bought one just like that. Paid about 1/2 that though. Really help getting on boat when putting boat in water alone!
20190413_200035.jpg