Anyone have a Bob's jack plate wiring diagram?

[ethosb]

Indicator dash gauge quit displaying motor position and want to do a wire check or in-line fuse check. Nothing obvious broken or disconnected. It was installed by someone other than me, so no idea about the wiring harness. I did check the obvious inline fuse at the relays and it was good. Jack plate works fine.

Thanks,
Brian

[blkfalc4]

Make sure the magnet is close enough to the sensor on the plate.

[wmitch2]

Make sure the magnet is close enough to the sensor on the plate.

And the wires are fully connected to the back of the gauge.