Results 1 to 4 of 4
  1. 01-16-2020, 04:27 PM #1
    mr wayne
    mr wayne is offline
    Member
    Join Date
    Feb 2013
    Location
    SW Louisiana
    Posts
    190

    Water Pressure Hose

    I have an 07 225 Pro XS #1B446525. Want to know if the hose from pressure gauge goes to bottom of block somewhere under lower cowl? Wanting to disconnect it at block. Traced the hose till it goes under oil pump but cant see it past that. Just didn't want to pull lower cowl if not needed. Thanks
    Last edited by EuropeanAM; 01-17-2020 at 07:59 AM.
    2023 Timber Reaper 656, 2023 115 Pro XS, Tiller Handle
    Reply With Quote Reply With Quote
  2. JOE54
    JOE54 is offline
    Member
    Join Date
    Jun 2013
    Location
    LONGVIEW TEXAS
    Posts
    14,017
    #2 01-16-2020, 09:05 PM
    follow gray hose down port side to tee from w/p sensor one end goes to gage one to back of block just below coils
    .................................................. ...the scariest thing in life is the unknown ...................................
    Reply With Quote Reply With Quote
  3. mr wayne
    mr wayne is offline
    Member
    Join Date
    Feb 2013
    Location
    SW Louisiana
    Posts
    190
    #3 01-17-2020, 05:12 AM
    Thanks
    2023 Timber Reaper 656, 2023 115 Pro XS, Tiller Handle
    Reply With Quote Reply With Quote
  4. JOE54
    JOE54 is offline
    Member
    Join Date
    Jun 2013
    Location
    LONGVIEW TEXAS
    Posts
    14,017
    #4 01-17-2020, 07:12 AM
    yes sir
    .................................................. ...the scariest thing in life is the unknown ...................................
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »