Wiring help 03 VMAX HPDI
i have a 03 Vmax 150 HPDI that i repower my 93 Ranger 361 with. The donor boat only had a tach on it. i replaced the Ranger tach with yamaha's 6Y7-83540-60-00 tach. work perfect. I've ordered the oil and trim sensor harness 6y5-83653-10-00. I have the factory yamaha wiring harness. where does the oil & trim harness connect to motor?
Contact Andy at Sims Yamaha. He can help you out.
There are two ivory coloured four pin nylon connectors in the front of the engine pan. The trim/oil harness will connect there.
I don't think you have ordered the correct trim/oil harness. Part number 6y5-83653-10-00 that you mention has but one four pin connector at each end.
Does your -60-00 tachometer have a four pin connector and a single wire with a bullet connector or does it have only the four pin connector? Does it have two lights or three lights? Makes a difference.
Thanks for the quick replies. This is what I have. Screenshot_20191211-085501_Amazon Shopping.jpg20191211_085550.jpg20191211_085615.jpg
I will check 1st hand this evening.
20191211_093421.jpg
This is what I was going by
That diagram is for a 2005 and later model Yamaha.Originally Posted by Vabasser3
The diagram that I posted applies to your model motor and the tachometer and trim gauge that you have.
Last edited by Vabasser3; 12-12-2019 at 08:14 AM.
Reply With Quote