Power Pole Pump Removal

[Mark Wendler]

Did some searching, but did not find an answer.

My 2017 Z520C has the pumps factory mounted on a nylon block in the setback. Need to remove the pumps due to one pump bleeding down constantly. In feeling around, I can only find one bolt, between the 2 pumps, in the middle of the nylon block. Surly there are more bolts/screws holding this block in, but I can't find anymore. Also, can I fit them through the splashwell, or do I need to remove the charger and batteries?

[Rip Bass]

No way of knowing how many bolts you have but you will need to remove them through the bilge,pumps won’t fit through the access hole in the splash well.

[1BADAIR]

They are bolted thru the back of the nylon then the nylon is screwed to the boat .

[bbbill]

Yes there is only one bolt. it's like a wide threaded lag bolt. It's a PITA to get in and out. Had to reinforce mounting hole w/ some JB WELD Epoxy.

[Mark Wendler]

Yes there is only one bolt. it's like a wide threaded lag bolt. It's a PITA to get in and out. Had to reinforce mounting hole w/ some JB WELD Epoxy.

Thanks Bill.