Remote Drain Plug

[dannov5]

Anyone installed the Flow Rite Drain plug on a 721? Any tips? Think I'm going to order one, but wanted to seek some helpful advice before doing so.

Thanks!

[kry29]

I did it. It wont just switch out because Phoenix uses a bigger plug than what the flow rite is. Takes a little work to make it look stock but I did it in about an hour. I took the chrome plug off the boat and ground out all the insides so the chrome cover will fit over the flow rite plug. Then I barely ground some plastic off the flow rite so it fit under the chrome cover and it would all look good. Then I used some 4200 and sealed the inside of the hole where the plug goes and then used a lot of 4200 and put it all together on the boat. Just make sure you keep the screen and the plug hole clean so the flow rite works right.

[dannov5]

Thank you!