good afternoon, i have the following molds:
SPJ-3-ATK
BSH-3-SA
the questions:
i poured the jigs with the weed guards in, it went well, only a few bad ones. Now i want to powder coat them, i have Teflon tubes, and painting is going OK, but when i go to bake them for the finish, the tubes slide off or the weed guards sag, or they flare out and sag, any tips or ideas, i tried to use tape to hold them, but it gets to hot and it melts the glue on the tape. i may try foil next time or maybe foil to hold the tubes in place. I have a fluid bed with a built in vibrator.
any tips would be great
thank you
terry