Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    May 2005
    Location
    Manitowoc
    Posts
    53

    2000 19SS Parts Exchange

    I am looking at a 2000 19SS that is in rough shape. All the black panels are in poor condition from the sun. This includes the bow, dash, drivers side and passenger side panels. The black coating is pretty much gone and the foam beneath is pretty deteriorated.

    My question is, how close would panels from other models fit?

    Thank you!

  2.  
  3. Member
    Join Date
    Dec 2013
    Location
    Spring Hope,NC
    Posts
    5,010
    #2
    To the best of my recollection,the consoles in the SS series were the same,even the bow panels too if they were the same year model. There was some minor changes from year to year. To be honest,I ran a 2000 21 SS and hated that boat. That concave pad was a very poor design and was poorly built too. The little outside wedges on the pad were not cast into the hull and would eventually come off. Look at the pad very close before you buy.But,if you can find an intact plastic piece,it can be vinyl wrapped or sprayed with plastic-dip and look nice.

  4. Member
    Join Date
    Apr 2014
    Location
    Xenia, Ohio
    Posts
    5,967
    #3
    19-20ss totally different than 21ss hull
    2000 stratos 20 ss (bought new)
    200 hp Rude ficht -re200flssh
    twin 12 ft. talons-blue water leds
    hook 7 and lms520c
    pulled by a 2500HD Denali
    bravo1 fs croxtonized
    proud dad of an ARMY Lieutenant. (Back home finally)
    proud uncle of an ARMY Sergeant
    member of "team deplorable" MAGA
    ASE/GM Master tech before tools