Blowing fuse

[Castleberry68]

I have 2017 cm2 10ft blades. One of my blades works fine. The other one keeps blowing fuses. What could be the issue?

[Hydrilla Gear]

Does the pump make any noise prior to popping fuse?

I would see if the pole goes up and down and then blows the fuse because that would tell us if something is locking up or not. If it blows the fuse just sitting there then its probably the board. But if you try to run it and it makes like a clunking noise or grinding noise and then blows something is probably locking up in the base or the motor

[Castleberry68]

I have not got it to blow fuse again. But when I put the pole in up position, when it is in full up the pump keeping running until I hit the up or down button one time. Then it stops and pole stays where it is suppose too.

[KandKKustomz]

you need to change the sensitivity setting for that pole. This can be done on the pump itself or thru the app. You are going to want to INCREASE the sensitivity of the one thats overrunning when being stowed.

[Castleberry68]

Ok I will try that. Thank you very much

[KandKKustomz]

Ok I will try that. Thank you very much