Some manufactures use a dipped pinning screw that already has the adhesive on them.
Just a little update on the ole Falcon.....went into my mechanic today finally.....he is stripping rub rail off on both sides thankfully and completely doing it right.....gluing between cap and hull and I purchased those Simpson fiberglass screws and he is gluing and installing those. Should be done sometime tomorrow. I cannot wait to get this done and move on from it!
2019 Falcon 215 Yamaha Sho 250, Lithiums, X2, Poles, Ultrex, Birds, Mega 360 & Livescope.
Previous-2017 Falcon 205 Evinrude G2 250HO, Lithiums, Poles, Ultrex, Birds and 360.
Okayyyyyy......so boats done thank gosh. He took entire rub rail off both sides and said he immediately knew what the issue was......the only thing holding the cap and hull together was a screw every foot or so......thats it. He found a lot of screws that were broke as well. So he ended up gluing hull and cap and adding a screw in between each of the other ones and then took out all the broken screws in rub rail and added extra in of the new screws I bought.....im excited and hoping the issue is over with....I walked around the boat pulling up and down on the rail and it doesnt budge a smidge.....before almost every foot I could do it and it would move. Fingers crossed this issue is marked off the list!
2019 Falcon 215 Yamaha Sho 250, Lithiums, X2, Poles, Ultrex, Birds, Mega 360 & Livescope.
Previous-2017 Falcon 205 Evinrude G2 250HO, Lithiums, Poles, Ultrex, Birds and 360.