Tie Down Engineering Caliper question

[3ptbuck]

2018 Nitro z19 trailer, sorry dont know that model off hand.. Had to replace passenger(truck not boat) side caliper. Part # 46304. The way mine is set up the bottom hole is a plug and the top 2 are a bleeder and the brake line hook up from opposite side.
New part comes with feed fitting in the bottom and blenders on the top. Same replacement OEM part.

Do I leave it how it is or set up like mine was originally? I believe these parts are used on both sides so different configurations are possible, making me lean towards it being ok to switch it to old setup.

[leonreno]

You can configure the way you want but having the line come in from the bottom would normally allow the air to escape easier when bleeding. However, if there is clearance issues then the original way should work too.