I hit a stump pretty hard and snapped my ultrex shaft and it started to rip the mounting bolts out. Now my TM moves side to side when in use. All bolts are tight. What is the best fix? Take it to a fiberglass shop?
I hit a stump pretty hard and snapped my ultrex shaft and it started to rip the mounting bolts out. Now my TM moves side to side when in use. All bolts are tight. What is the best fix? Take it to a fiberglass shop?
2000 Ranger 522SVX W/ 2000 Mercury 250XB
U.S. Air Force Retired
Any visible damage from the top...either way prolly gonna have to re-glass and reshoot where the TM is at.
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
No visible damage on top
2000 Ranger 522SVX W/ 2000 Mercury 250XB
U.S. Air Force Retired
Take a look underneath and see what is going on. I would think that even if some of the holes got ovalized from an impact if the bolts are tight than the mount shouldn't move. If you haven't already, remove the mount from the boat and inspect the top and underside of the mounting area before taking it to a shop.
Are you using stainless steel bolts, fender washers and lock nuts, or the rubber mounting isolators???... I'd go the stainless bolts, fender washer and lock nut way... Dan