was wondering if anyone did this. sister up three 2x10 boards (one on each side in back and one for up front) and fix a cross member beam with two chains in back and one for up front.
was wondering if anyone did this. sister up three 2x10 boards (one on each side in back and one for up front) and fix a cross member beam with two chains in back and one for up front.
Best to use straps fore and aft, then lift boat off trailer.
Yes,
I built a rolling carriage that goes under the flat section of the hull between the drain plug and transom.
$40 in treated 4x4 and some casters.
Lower the trailer jack all the way and it should be built to just slide under the boat.
Lift the bow using straps through the bow eye. The boat should bear weight on the carriage and lift completely off the trailer. Once the boat is high enough raise the trailer jack to level and pull the trailer out.
Last edited by friogatto; 10-08-2019 at 12:59 PM.
I say not many guys have a lift for boat because I have not seen a video of a guy crushed while waxing the bottom of his bass boat .
Mike
2019 Ranger 520L w/ 250HO ETEC G2
2011 Tracker 175TXW w/ 75HO ETEC
Harbor freight has a cheap A frame my buddy uses and I borrow 2 inch strap under rear and cherry picker on the front jack stands after trailer is out.
1994 Stratos 201 Pro XL 2004 Mercury 200 EFI
that foldable system is very similar to the harbor freight A frame but twice the money
Can you link to the habour freight version you use.
2023 Phoenix 920 Elite
2023 Mercury Pro XS 4S
Brownell MB4 18"-25" Boat Stand https://www.amazon.com/dp/B007CMQ7JW...p_mob_ap_share
I use these in the shop...they make a keel stand also
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
Mike
2019 Ranger 520L w/ 250HO ETEC G2
2011 Tracker 175TXW w/ 75HO ETEC
not bad at all
whats the name of that and what weight is it rated for
Last edited by blkfalc4; 10-10-2019 at 04:38 AM.
Mike
2019 Ranger 520L w/ 250HO ETEC G2
2011 Tracker 175TXW w/ 75HO ETEC