Results 1 to 4 of 4
  1. 09-20-2019, 11:24 AM #1
    Stratos1387
    Stratos1387 is offline
    Member
    Join Date
    May 2014
    Location
    Louisville, Ky
    Posts
    243

    Stratos 200 Pro Xl help

    03 200 pro xl 225 Yamaha HPDI. 8 inch plate at 3in below pad. Getting 68mph at 5000rpm 18psi water pressure. Turning a 26 turbo lightning prop. Need suggestions of what to do.
    Reply With Quote Reply With Quote
  2. TwinStick
    TwinStick is offline
    Member
    Join Date
    Apr 2010
    Location
    Canton, Ga
    Posts
    862
    #2 09-20-2019, 07:40 PM
    Sounds low on the rpms. Make sure your guage is correct. Mine runs good about 2.5-1.75 below the pad. I run a 27t1. Can run 72.5 in the Georgia heat. Ran 74.6 with a 26 solas, but got rid of that prop.
    Reply With Quote Reply With Quote
  3. BuzzB8
    BuzzB8 is offline
    NC Bass Club/Yamaha Motors Moderator BuzzB8's Avatar
    Join Date
    Jun 2004
    Location
    Asheboro, NC
    Posts
    7,072
    #3 09-20-2019, 07:46 PM
    Raise the engine to 2 5/8 below the pad, and a 27" Yamaha T1 prop balanced and blueprinted with a little extra cup for bow lift. You should be somewhere around 5800 RPMs wide open and trimmed out. You should be seeing mid 70s.
    Reply With Quote Reply With Quote
  4. TBOGEYBOGEY
    TBOGEYBOGEY is offline
    Member
    Join Date
    Feb 2005
    Location
    JAMESTOWN
    Posts
    43
    #4 09-22-2019, 08:23 PM
    I run a 07 200xl with a 225 etec. I had trouble with my set up initially as my tach was way off. I installed nmea network and get live engine data. I run a 27 renegade at 5500 rpm for 74mph loaded. 28 raker 2 5700rpm for 78mph. Same set back 2.75 below pad.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »