Does anyone know the part number for Flo-torq IV (four) hub kit for Yamaha SHO (originally with 2 part thrust washer)??
Does anyone know the part number for Flo-torq IV (four) hub kit for Yamaha SHO (originally with 2 part thrust washer)??
This is the one I used but it may not be the one you are looking for: 8M0075402
Oh. I run the Bravo 1 XS with it. No problems with mine. But mine is the one piece not the 2 piece. Sure someone on here can tell you the right one.
ok, you've got me thinking now...I know you have a SHO 4stroke. Do you have any vent holes open on your Bravo 1? My new prop is a Razor 4 with all holes plugged. Maybe if I tried opening a hole or 2 it would let enough air out to stop the chatter, unless it screws up the holeshot??
Mine is actually a bravo 1 FS ( four stroke) that Mark put the extra 4 holes for an XS to run on a mercury. So I have the 4 holes plugged solid and 1 PVS plug. Hope that makes sense.
Is your motor is a 4 stroke or 2 stroke? And you have 1 vent hole open?
It's a 250 SHO 4 stroke. I have one pvs hole with a plug ( I can't remember if it's a med or large though).
The 1st pic is with the solid plugs all outer holes. If you look carefully at the hole on the top is the PVS plug.
Bravo Prop 1.jpg
This how my prop is on my motor
A1C4523C-8DAD-4F02-B91A-1BE3DD88DD3F_1_201_a.jpeg.
Last edited by tracer1; 09-11-2019 at 09:53 AM.
ok, thanks for the info.